Trust PREMIUM Serie Mode D'emploi page 4

EN ZPIR-8000 MOTION SENSOR
COMPATIBILITY
The sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.
1. (RE)PLACE THE BATTERIES
A Remove the battery cover from the sensor.
Place 2x AAA batteries (not included) in the sensor. Note the positive and
B
negative polarity in the compartment. Close the battery cover.
2. INDICATORS
The sensor contains a LED indicator (This is not a button) to show the status of
the sensor. Please see below the meaning of the different LED indications.
LED FUNCTION TABLE
Connection mode
Connected successfully
Sensor reset
Sensor triggered (When motion
is detected)
4
LED will flash once per second for
approximately 1 min. (After 1 min the
LED will stop flashing)
LED will stop flashing (The App will
also indicate when the connection is
successful)
LED will flash fast (for 2 seconds)
LED will flash once