Special Cleaning Instruction - STA-RITE System 2 PLM100 Notice D'utilisation

Recommended Specialty Filter
Cleaners
Filter Cleanse™, Strip-Kwik
®
KleenIt™, Softswim **, Filter
Kleen™, Baqua Clean™
** MUST be used when using
any PHMB based sanitizer.
Filter Cleanse™ is a trademark of Advantis
®
Technologies, Inc., Strip-Kwik , KleenIt™, and
®
Softswim are trademarks and/or registered
trademarks of Bio-Lab, Inc., Filter Kleen™ is a
trademark of Haviland Consumer Products,
Inc. and Baqua Clean™ is a trademark of
Zeneca Limited Corp.
module. If the filter requires acid cleaning, have a trained pool professional
do the job.
NOTICE: When sanitizing your pool using PHMB (polyhexamethylene bi-
quanide based) cleaners, use only PHMB cleaners to clean the module.
When using PHMB sanitizers, the filter module MUST be cleaned more thor-
oughly and frequently than for a pool using chlorine. Follow manufacturer's
instructions carefully. Use of any other type of cleansers with PHMB pool
sanitizers will void the filter's warranty.
NOTICE: Avoid washing filter debris into the outlet port. Remove drain plug
and flush foreign material from inside of tank before removing filter module.
1. With a hose equipped with a soft flow nozzle, wash as much dirt as possi-
ble off of the filter module while it is still inside the tank. Allow tank to drain
completely.
2. Make sure that the inside of the tank is clean. Lift out the module and
hose it down thoroughly. Spray the entire module surface. Allow module to
drain.
3. Inspect the module. If necessary, repeat the washing operation. If the
module is damaged, replace it.
NOTICE: If this cleaning method does not remove all deposits, see
"Special Cleaning Instructions" section in this manual.
4. Inspect and clean air bleed filter at top of module.
5. Follow all steps in the "Assembly" and "Initial Startup" sections of this man-
ual.
Special Cleaning Instructions:
Use this procedure to clean scale or oils which are not removed by hosing
down module. Be sure to dispose of spent chemicals according to all applica-
ble codes and waste disposal ordinances. Use a soft stream nozzle to mini-
mize flying water and spray.
®
,
cal cleaning; rinse filter and elements completely before returning to service.
If filter cannot be isolated, remove media and clean at another location.
Follow chemical manufacturer's instructions for use. Do not mix chemicals
except as directed by manufacturer. Do not allow cleaning chemicals to mix
with or to come in contact with chlorine, bromines, other chemicals, or chemi-
cal feed devices.
1. Sponge or spray the module according to chemical manufacturer's direc-
tions.
2. If soaking is required, remove the module from the filter tank and sub-
merge it in a separate tank. Follow cleaner manufacturer's instructions
carefully.
3. After completing chemical manufacturer's instructions, drain and rinse the
module completely. Dispose of cleaners in accordance with local codes
and disposal ordinances.
4. Rinse the inside of the filter tank. Drain it completely.
5. Follow instructions in the "Assembly" and "Initial Startup" sections of this
manual.
Risk of chemical burns. Do not attempt to acid clean the filter or
Risk of fire or explosion. Isolate filter from system before chemi-
Compliments of www.poolsandstuff.com
8