Flex ALR 411 M Notice D'emploi page 15

Rotational laser
Required batteries:
– 1 x 9 V-unit.
n Push down and remove the battery
compartment cover from the remote
control.
n Insert the 9 V unit as indicated.
n Close the battery compartment cover.
Wall and tripod bracket
Note
For optimum results it is recommended to
attach the machine to a tripod (accessory).
– Tripod thread: 5/8"
The ALR can be rotated on the wall and
tripod bracket through 4 notched positions
(90° each).
Switching the power tool on
and off
Note
The On/Off button (2) has the following
functions:
– Press 1x: switches on the machine
– Press 2x: switches on the hairline
function
– Press 3x: switches off the machine
Switching on the power tool:
n Press the On/Off button (2) on the
machine once. The LED (3) is lit.
Switching off the power tool:
n Press the On/Off button (2) on the
machine until the LED (3) goes out
or
Press the Off button on the remote
control.
Note
When switched on, the power tool always
starts in the "rotating laser beam" operating
mode.
Changing the speed of rotation
To reduce the speed of rotation in "rotating
laser beam" standard operating mode:
n Press and hold down the arrow button t
(4) on the power tool or on the remote
control until the beam is rotating at the
required speed.
To increase the speed of rotation:
n Press and hold down the arrow button s
(4) on the power tool or on the remote
control until the beam is rotating at the
required speed.
Switching over the operating
mode
To switch from the "rotating laser beam"
standard operating mode to the other
operating modes:
n Press the mode button (5):
– 1x = scan 1 (line)
– 2x = scan 2 (oscillating beam)
– 3x = point
The operating mode LED (1) flashes.
To change the position of the beam for these
operating modes:
n Press the arrow button t (4) on the
power tool or the remote control to
adjust the position of the beam in
a clockwise direction.
15