Sauder Executive Desk 412902 Instructions De Montage page 10

Step 3
NOTE: Before beginning this step, separate the NARROW EXTENSION
å
SETS (AAA and BBB) from the WIDE EXTENSION SETS (CCC and DDD).
Do not confuse these SETS once they are separated.
Separate the NARROW EXTENSION SLIDES (BBB) from the NARROW EXTENSION
å
RAILS (AAA) as shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the NARROW EXTENSION RAILS (AAA) to the ENDS (B3 and C3) and
å
UPRIGHTS (D2 and E2). Use sixteen GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the END and UPRIGHT. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
AAA
Open end
Page 10
BBB
Push the release lever in and pull the SLIDE from the RAIL.
AAA
C3
AAA
Open end
Open end
AAA
AAA
E2
AAA
D2
412902
AAA
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
Open end
AAA
AAA
B3
www.sauder.com/services
3S