Sauder Executive Desk 412902 Instructions De Montage page 28

Step 21
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the right diagram. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the DOOR (L) to the LEFT END (C3). Use the screws in the
å
HINGES. See the next step for door adjustments.
Peel a FELT DISC from the FELT DISC CARD (1M) and stick it on the
å
DOOR where it comes in contact with the LEFT UPRIGHT (E2).
Push the RUBBER SLEEVES (2R) over the remaining METAL
å
PINS (1R). Insert the METAL PINS into the hole locations of your
choice in the LEFT END (C3) and LEFT UPRIGHT (E2). Set the
ADJUSTABLE SHELF (M) onto the METAL PINS.
Insert a GROMMET (10P) into the large hole in
å
the BOTTOM (G2).
Page 28
E2
10P
412902
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
C3
M
L
G2
2R
www.sauder.com/services
1M
1M
1R
(4 used)