MINN KOTA 1810388 Mode D'emploi page 4

2
c. Install the Sandwich Brackets between the Transom
and Jack Plate. Use the hardware that was already on
the boat to install the Sandwich Brackets. Reinstall
the mounting hardware loosely. The hardware should
pass through the Transom, the Universal Sandwich
Adapter and the Jack Plate.
d. Once the Sandwich Brackets are positioned, tighten
and torque the mounting hardware to the boat and/
or outboard manufacturer's specifications. The
installation of the Universal Sandwich Adapter
is complete. To install a Jack Plate Bracket to
the Universal Sandwich Adapter please see the
instructions provided with the Jack Plate Bracket.
Installation Between Jack Plate and Outboard
1
ITEM(S) NEEDED
NOTICE:
The Outboard doesn't have to be
completely removed. Remove the two mounting
bolts from one side and loosen the mounting bolts
on the opposite side. Tilt the Outboard motor for
the installation steps below. Repeat for opposite
side to complete installation.
a. Support the Outboard and remove the hardware that
attaches the Outboard to the Jack Plate.
b. Take the Sandwich Brackets (Item #2) and apply
marine grade silicone to all of the transom-side
Mounting Holes on both brackets.
4 | minnkotamotors.com
#2 x 2
2c Transom Transom
Sandwich Sandwich
Bracket Bracket
Jack Jack
Plate Plate
Port Port
2d
Transom Transom
Sandwich Sandwich
Bracket Bracket
Jack Plate Jack Plate
Port Port
NOTICE:
This installation method is NOT compatible
with Atlas Jack Plates (all offsets). Installation with
Bob's Machine Shop Jack Plates will require Spacer Block
Kit #1810211.
Port Port
Transom Transom
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Mounting Mounting
Holes Holes
Outboard Outboard
Sandwich Sandwich
Bracket Bracket
Starboard Starboard
Outboard Outboard
Sandwich Sandwich
Bracket Bracket
Starboard Starboard
Transom Transom
Starboard Starboard
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Silicone Silicone
©2021 Johnson Outdoors Marine Electronics, Inc.