MINN KOTA 1810388 Mode D'emploi page 2

3. The Universal Sandwich Adapter can be mounted in 3
possible ways:
a. between the Jack Plate and Transom
b. between the Outboard and Jack Plate or
c. between the Outboard and Transom.
The mounting instructions are described below and
will be similar for all installation methods or Jack Plate
offset options.
NOTICE:
The Outboard does not have to be completely
removed. Remove the mounting bolts that secure the
Outboard to the Transom from one side and loosen the
mounting bolts on the opposite side. Tilt the Outboard
motor for the installation steps below. Repeat for the
opposite side to complete the installation.
NOTICE:
Check with your Jack Plate or Outboard
manufacturer to determine if additional hardware
is needed to accommodate installing this Universal
Sandwich Adapter.
INSTALLATION
Installation without Jack Plate
1
ITEM(S) NEEDED
a. Support the Outboard and remove the hardware
that attaches the Outboard to the boat Transom.
b. Take both Sandwich Brackets (Item #2) and apply
marine grade silicone to all of the transom-side
Mounting Holes on both brackets.
2 | minnkotamotors.com
3a
3c
#2 x 2
Jack Plate
Transom
Outboard
Transom
Outboard
Complete Typical Installation
Port Port
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Transom Transom
Bracket Bracket
Mounting Mounting
Holes Holes
Sandwich Sandwich
Bracket Bracket
3b
Jack Plate
Transom
Outboard
NOTICE:
Universal
Sandwich Adapter
shown with a Jack
Plate Bracket.
Starboard Starboard
Sandwich Sandwich
Transom Transom
Sandwich Sandwich Bracket Bracket
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Silicone Silicone
©2021 Johnson Outdoors Marine Electronics, Inc.