MINN KOTA 1810388 Mode D'emploi page 3

2
c. Install the Sandwich Brackets between the
Outboard and the Transom. Use the hardware that
was already on the boat to install the brackets.
Reinstall the mounting hardware loosely using
the Mounting Holes that align with the existing
hardware. The hardware should pass through the
Outboard, the Universal Sandwich Adapter and the
Transom of the boat.
d. Once the brackets are positioned, tighten and
torque the mounting hardware to the boat and/
or outboard manufacturer's specifications. The
installation of the Universal Sandwich Adapter
is complete. To install a Jack Plate Bracket to
the Universal Sandwich Adapter please see the
instructions provided with the Jack Plate Bracket.
Installation Between Jack Plate and Transom
1
ITEM(S) NEEDED
NOTICE:
The Outboard doesn't have to be
completely removed. Remove the two mounting
bolts from one side and loosen the mounting bolts
on the opposite side. Tilt the Outboard motor for
the installation steps below. Repeat for opposite
side to complete installation.
a. Support the Outboard and remove the hardware that
attaches the Jack Plate to the boat Transom.
b. Take the Sandwich Brackets (Item #2) and apply
marine grade silicone to all of the transom-side
Mounting Holes on both brackets.
3 | minnkotamotors.com
2c
2d
Sandwich Sandwich
#2 x 2
Transom Transom
Sandwich Sandwich
Bracket Bracket
Port Port
Transom Transom
Bracket Bracket
Sandwich Sandwich
Port Port
Bracket Bracket
(Any Manufacturer)
Port Port
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Transom Transom
Bracket Bracket
Mounting Mounting
Holes Holes
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Outboard Outboard
Starboard Starboard
Outboard Outboard
Starboard Starboard
Starboard Starboard
Sandwich Sandwich
Transom Transom
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Sandwich Sandwich
Bracket Bracket
Silicone Silicone
©2021 Johnson Outdoors Marine Electronics, Inc.