SIGNIFY Stonco KEENE AL70 Instructions D'installation

Area Light AL70 & AL150
Installation Instructions
WARNINGS
• Before starting ensure that the power is disconnected.
• All gaskets and hardware used on luminaire must be in place.
• Obey all torque requirements to prevent danger of falling
luminaires or falling parts.
PREPARE ELECTRICAL WIRING
Electrical Requirements
• The LED driver must be supplied at 120~277V, 50/60 Hz and
connected to an individual, properly grounded branch circuit
protected by a 20-ampere circuit breaker. Use min 75
Grounding Instructions
• The grounding and bonding of the overall system shall be done in
accordance with NEC Article 600 and local codes.
• When servicing maintain the ground connection between the
luminaire and lid.
1
• Use the Pole Mount Flat Bracket to secure
the thread rods to the pole. The slotted ends
should be facing away from the pole.
• Align with the holes in the pole and thread
through the the Pole Mount Flat Bracket on
the inside of the pole using a flat head
screwdriver.
Figure 1
Pole Mount
Bracket
Bracket
Washers and Nuts
9/22/2020 page 1 www.stonco.com
o C supply.
2
•Slide the pole mount arm over the
two threaded rods.
• Open the LED driver compartment from the
underside of the fixture.
• Feed the rods through the pole mount
gasket, and secure the fixture to the pole
mount using the spring washers and nuts
inside the compartment. Tighten to 132in-lbs.
Pole Mount Arm
Pole Mount Arm Rods
Driver Compartment Door
www.keene-lighting.com
Site & Area Light
LED Site & Area
AL70 & AL150 Area Light
Tools Required:
#2 Phillips Screwdriver
5/16"-18 Threaded Arm Rods (2x)
Flat Head Screwdriver
Wire Strippers
Wire Cutters
Hex Bit Socket Wrench
or Combo Wrench (1/2")
Pole Mount Flat Back Bracket (1x)
Silicone Caulk
Pole Mount Flat Gasket (2x)
Figure 2
Pole Mount Flat Bracket
Gasket
O-ring
Hardware Supplied:
5/16"-18 Hex Nut (2x)
Lock-Washers (2x)
O-ring (2x)
Fixture Flat Bracket (1x)
3
• Connect the power leads with the
included wire nuts according to the wiring
diagram.
• Close the LED driver compartment door
and secure it with the supplied screws.
Figure 3
Figure 4