CERA-Design faro Manuel page 46

Assembly of Faro feed air connection "at rear"
To connect a feed air pipe from the rear, the "air grille" in the rear needs to be "opened"
under the steel cover.. In this case the opening has already been glazed and is only
connected to the rear panel walling with small webs. These webs have to be cut through so
that the feed air connection can be fitted from the rear.
These webs have to be
cut through and
panel has to
removed so that a feed
air duct can be fitted to
the feed air connection
from the rear.
If the feed air opening
has been closed off
with a cover, the cover
(4 screws) needs to be
removed.
After this, an adapter
panel is screwed on (at
the location where the
cover previously was).
The feeder connection
can be fitted to this
adapter plate and the
combustion air pipe can
then be connected to it.
45
the
be