CERA-Design faro Manuel page 45

Assembly of Faro feed air connection "below"
If the feed air connection is
installed on the Faro from
underneath, this must be stated on
the order. In this case, the feed air
connection will be fitted to the base
at the works.
The "air grille" must then be
removed from the rear wall. To do
this, the webs are cut through and
the air grille panel is removed.
After this, the Faro is laid on its
side and the cover for the feed air
opening on the base is unscrewed
(4 cheese-head screw size 4 mm).
The feed air connection is now
pushed through and installed here.
The Faro and the fitted feed air
connection is now righted and the
connection is "pushed into a
connection in the floor" or
connected to a feed air duct.
Alternatively the Faro can be
placed on a prepared feed air
opening in the floor (without a
connection) and in this case a felt
layer under the footplate will seal
off the connection (not permissible
if air extraction equipment is
present).
44