Door Reversibility - Caviss V1150TBE4 Notice D'utilisation

You can change the direction of the door opening of your appliance by moving the hinges.
When reassembling, make sure that the door is aligned with the abinet and that the seal
adheres correctly.
We remind you that the change of the direction of opening of the door must be
made with the device disconnected.
Overview
If you need to change the direction in which the door opens, you will need to
remove the door, reverse the position of the hinges and pull up the door.
To perform this operation, you will need some tools and some skills, if you do not feel
comfortable call your after-sales service.
2
1
Removing the door
Take special care because the door is very heavy, pull the top hinge door and put it in a safe place.
5
Assembling the door in the new position
Be careful because the door is very heavy, align the door and push up to get the pin into the hole.
Lower hinge assembly
Change the side (2) of the lower hinge with a suitable key.
Fit the plastic washers (3) on the axle and insert the axle into the hole in the
door.
Screw the screws (5) keeping the door aligned with the cabinet.
Screw both front feet (1).
Restart your wine cellar
Check if all screws are tight.
Raise your cellar taking care not to slip (especially if it is provided with rear wheels).
Assemble all internal accessories.
Wait two hours before restarting as described in the "Installation" chapter.
Made in Europe
Imported by SIDEME SA – BP200 – 92306 Levallois Perret cedex

DOOR REVERSIBILITY

Remove the bottom hinge
Remove all accessories from the inside, close the door and place the unit on
its back on a stable surface.
Unscrew both front feet (1).
Unscrew the axis of the hinge (2) and take the plastic washers (3).
3
Unscrew all screws (4) to remove the lower hinge (use a Phillips screwdriver).
4
Changing the axis of the upper hinge
Unscrew the axis of the upper hinge (5) and move it to
the opposite side. Screw the axle to the stop.
31
EN
2
3
1
4
MPPAPMAN6100303