Troubleshooting And Solutions - Caviss V1150TBE4 Notice D'utilisation

TROUBLESHOOTING AND SOLUTIONS

The controller displays an alarm or warning code if something is not consistent with the expected. This message
appears alternately with the internal temperature until the alarm conditions are stopped.
To understand the meaning of the code and what to do in front of it, please refer to the table below.
Code Cause
High temperature
HA
alarm
Low temperature
LA
alarm
Failure of the
P1
thermostat probe
The light does not come on with the door open.
Check if:
- The plug is not inserted in the socket or not inserted enough to make contact.
- There is no power in the house.
The wine cellar does not cool well or the compressor runs constantly.
Check if:
- The door is closed properly or if the seal is damaged.
- The door is opened too frequently.
- The installation conditions are respected.
The device makes too much noise.
Check if:
- The device is well leveled.
- The unit has been installed between furniture that vibrates and makes noise.
- The installation conditions are respected.
- The internal fan is free and unobstructed..
- This is the noise that the refrigerant makes, which occurs even when the compressor is off (this is not a fault).
The inner rear wall of the unit is covered with frost or water droplets.
- This is the normal operation of the device.
There is water in the inner bottom of the device
Check if:
- The drain hole is not obstructed.
A certain amount of water is normally present in the water drain, which will ensure good moisture control in the unit.
If, after these checks, the appliance does not work or the problem persists, contact your after-sales service
communicating:
- type of dysfunction;
model of the device;
-
serial number of the device.
-
This information can be found on the nameplate located inside the device.
Never use unauthorized technicians and always refuse spare parts that are not of manufacturer's origin.
Action
This message appears if the controller is not able to bring the internal temperature to
the setpoint.
Check whether the device is correctly installed and that the climatic conditions of the
room comply with the specifications (see chapter "Installation").
If there has been a change in set point, a large load change, or a long door opening,
the cellar must be allowed to stabilize.
If you are unable to solve the problem, contact your after-sales service.
Contact your after-sales service, with this defect your device will stop working.
30
EN