Caviss V1150TBE4 Notice D'utilisation page 24

To ensure that the unit operates properly and to reduce power consumption, it is important that the unit is
properly installed.
Terms and conditions
Do not place your device in a flooded room. Avoid splashing water on the control panel and at the rear of the unit.
Ventilation
The compressor and condenser generate heat and need to be ventilated properly. Rooms with no ventilation are not
suited for the installation of this appliance. Therefore, it should be installed in a room with an opening (window or
French window) that provides the appropriate amount of air re-circulation.
For proper ventilation of the appliance, leave a space of at least 10cm around it and any adjacent cabinets/walls
Room Temperature and Humidity
Room temperature should be according to the climate class of the appliance. Please look at the rating plate (inside
the appliance) to see the climate class of your wine cellar and compare it with the following ranges:
Symbolo
SN
N
ST
T
SN-T
Note : Despite this standard range, your appliance will work correctly even in a room with temperature starting from
0ºC.
Room relative humidity should be in the range of 50% to 75%. Outside this range the appliance will do his best to
bring internal humidity to set point but, depending on the load and temperature set point, this cannot be guaranteed.
Away from Heat
Avoid positioning the appliance in a place where it is directly exposed to sunlight, nor near an oven, cook top or other
similar equipments
Upgrade the device
Your device must be installed in a flat, stable and vibration-free surface.
Put the wine cellar in position, then adjust the front legs (by screwing or unscrewing) to bring it level, the use of a
spirit level is recommended.
Cleaning
Before connecting the power plug, clean the cabinet and accessories with a solution of water and mild detergent.
Earth Electrical Connections
Before connecting the power cord, clean the compartments and accessories with water and a mild detergent solution.
Electrical and Earth Connection
Before proceeding with the electrical connection, make sure that the voltage indicated on the rating plate, located
inside the appliance, corresponds to the mains voltage in your home and that the socket is fitted with a standard
earth wire in accordance with safety standards. If the socket is not fitted with an earth wire, the manufacturer will not
assume liability for any damages and/ or injuries arising out of the use of the appliance. Do not use multiple sockets
or adapters.
Position the appliance in such a way that you can access the socket where it is plugged in.
Insufficient Power
The electrical socket must be able to handle the maximum power load of the appliance, which is indicated on the
rating plate located inside the wine cellar.
electrical connection
Your device is designed to operate at 230 volts single phase.
INSTALLATION
Class
Extended temperate
Temperate
Subtropical
Tropical
Extended temperate to tropical
Ambient range
+10 to +32ºC
+16 to +32ºC
+16 to +38ºC
+16 to +43ºC
+10 to +43ºC
23
EN