Black & Decker VPX1301 Manuel D'instructions page 11

90520983 VPX1301 Cut SAW
TREE TRIMMING
• Use a coarse blade when cutting tree limbs. Hold shoe firmly against tree branch. If
possible, cut close to the trunk to minimize movement of the branch.
PROJECT TIPS
• Cut only with sharp blades; they cut cleaner, faster and put less strain on the motor
while cutting.
• Place blade and shoe lightly against work to be cut. This will improve operator control
and minimize vibration.
• For longer blade life, use bi-metal blades. These utilize a carbon steel back welded to
high speed steel teeth making the blade more flexible and less prone to breaking.
• Use clamps or another practical way to secure and support the workpiece to a
stable platform. Holding the work by hand or against your body leaves it unstable
and may lead to loss of control.
• Switch on saw motor and allow it to obtain maximum speed before applying pressure
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
For assistance with your product, visit our website www.blackanddecker.com for the location of the
service center nearest you or call the BLACK & DECKER help line at 1-800-544 6986.
7/19/07 3:03 PM Page 11
TROUBLESHOOTING
Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature.
• Battery pack too hot or too cold.
11
Possible Solution
• Check battery pack installation.
• Check battery pack
charging requirements.
charger until red LED appears.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• If chargers are daisy chained
together check all connections.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle
is connected to a light
switch which turns power off
when you turn out the lights.
• Move charger and battery
to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• The charger will not
charge a battery pack if the
cell temperature is below
approximately 32° F (0° C)
or above 140° F (60° C).
The battery pack should be
left in the charger and the
charger will begin to charge
automatically when the cell
temperature warms up or
cools down.