Plastic Bag; How To Change The Bag; Tilting Discharge Device Replacement And Use; Compressor Use And Maintenance - Blastrac BDC1330 DBP Manuel D'instructions

Operating manual BDC1330 DBP/LPP

Plastic bag

You can use the plastic bags supplied by the manufacturer
sales network (Fig. 8).

How to change the bag

■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws
in force.
■ Take care not to raise dust during these
operations. Wear a P3 protective mask.
■ In case of dangerous and/or toxic dust, you
must use the supplied safety bag for these
vacuum cleaners.
■ The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
Tilting discharge device replacement
and use
1. Tilting discharge device assembly
■ Fasten the hopper to the filtering chamber, by inserting
it into the relevant housings and, operating on the lever
(2) to lock it.
■ Insert the bag (Longopac
and fasten its end with the belt (3).
■
Engage the tilting discharge device support to the
hopper by fastening it with the relevant pins.
■ Remove the bag (Longopac
support platform and close its end with the supplied
clamp.
■ When the bag is full (Longopac
with two clamps by fastening them at 50 mm one
GB from the other, then with a pair of scissors cut the bag
between the two clamps.
WARNING!
Figure 8A
) into the relevant support
®
) until it lays on the lower
®
) close the upper end
®

Compressor use and maintenance

WARNING!
Refer to the use and maintenance manual, supplied
with the machine documentation, when using or
servicing the compressor.

At the end of a cleaning session

■ Turn the vacuum cleaner off with switch (1 - Fig. 4),
turn the electric panel (7 - Fig. 5) off and disconnect
the plug from the socket (EU version)
■ Turn the vacuum cleaner off with switches (2-3-4 - Fig.
4), turn the electric panel (7 - Fig. 5) off and disconnect
the plug from the socket (US version)
■
Wind the connection cable up and hang it in the
relevant compartment (Fig. 9).
■ Empty the container as described in the "Emptying the
container" paragraph.
■ Clean the vacuum cleaner as described in the paragraph
"Maintenance, cleaning and decontamination".
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorised persons.
10/14
info@blastrac.eu