Safety Instructions - Intenso WPD10000 Notice D'utilisation

In alternative, connect your own cable to the port USB-A (USB-A 1 Out/USB-A 2 Out) or the
port USB-C (USB-C Out/In) of the power bank and the other end to the device to be charged,
according to the cable type. The charging process starts automatically and the devices inde-
pendently determine the respective charging current. If the charging process does not start
automatically, please activate the functional key. The fast charging is indicated by an LED as
well which now lights up blue. If the LED does not change from white to blue, your connected
device or the cable used are incompatible with the PD standard and the power bank will be
charged normally.
If a device is charged with the Powerbank and the capacity of the Powerbank is almost ex-
hausted, this is signalled by blinking of the last status LED. Please re-charge the Powerbank.
Please note that while charging a device with a Powerbank, about 30% of the total capacity is
used up just through the charging process. This is due, for example, through the loss of power
from circuit warmth and voltage conversion.
The Powerbank has to be used regularly for optimum performance. If this is not the case,
charge the Powerbank fully at least every three months.
Make sure that the warmth created through the charging process can be emitted from the
device (ideally place the Powerbank on a firm and heat-resistant base while in use).

SAFETY INSTRUCTIONS

Dangers for children and persons with restricted physical, sensory or mental
abilities:
Children often underestimate dangers or do not recognise them at all. This device is not intended
to be used by persons (including children) with restricted sensory, physical or mental abilities or
lack of experience and/or knowledge, unless they are supervised by a person responsible for their
safety or received instructions from the person on how to use the device and they have under-
stood the resultant dangers. Unsupervised children should not have access to the device. Make
sure that children do not play with the device.
General
If you have a pacemaker or another technical implant, please consult your doctor or the manu-
facturer of the implant, before using the Powerbank. Do not use the device in extremely cold,
hot, humid or dusty areas. Do not subject it to direct sunlight. Protect the product from open fire.
There is danger of explosion!
Protect the device in every operating state against impact and falling.
This device is sensitive to electrostatic discharge. Therefore protect the device against every pos-
sible electrostatic discharge.
To avoid malfunctions, do not connect the USB output ports of the device with USB ports of com-
puters or other devices. They are only intended for charging devices.
Do not disassemble to device into its component parts and do not try to repair it yourself. It does
not contain any parts requiring maintenance and the guarantee expires in this case.
Do not insert any items, which are not intended for its use, into the openings of the product. This
could lead to an electrical short-circuit and a resultant fire.
Do not operate this device with wet hands.
EN - Page 5 of 8