Troubleshooting; Battery Disposal; Important Recycling Advice - Petsafe PIG20-11041 Manuel D'utilisation

The Receiver
Collar is
beeping, but
the pet is not
responding
to the Static
Correction.
The Receiver
Collar activates
inside the
house.

Battery Disposal

This device operates on one battery of the type Lithium 3-Volt with 160
mAH capacity. Replace only with equivalent battery received from calling
the Customer Care Centre. For a listing of Customer Care Centre telephone
numbers, visit our website at www.petsafe.net. Separate collection of spent
batteries is required in many regions; check the regulations in your area
before discarding spent batteries. Please see page 3 for instructions on how to
remove the battery from the product for separate disposal.
___________________________________________________________________

Important Recycling Advice

Please respect the Waste Electrical and Electronic Equipment regulations
in your country. This equipment must be recycled. If you no longer require
this equipment, do not place it in the normal municipal waste system. Please
return it to where it was purchased in order that it can be placed in our
recycling system. If this is not possible, please contact the Customer Care
Centre for further information.
8

Troubleshooting

• Make sure the Static Correction Level is set at 2 or
above.
• Test the Receiver Collar with the Test Light Tool walking
toward the Boundary Wire.
• If the Test Light fl ashes, check the fi t of the
Receiver Collar.
• Trim your pet's fur where the Contact Points touch
his neck.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
• Purchase a stronger Receiver Collar by contacting the
Customer Care Centre.
• Turn the Boundary Width Control knob
counterclockwise to decrease the distance from the
Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running too close
to the house. The signal can transmit through the walls
of your house.
• Make sure Boundary Wires are twisted from Boundary
to the Fence Transmitter.
www.petsafe.net