Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Dust extraction
Optional accessory
Use the dust nozzle for dust extraction.
► Fig.21: 1. Dust nozzle
Installing the dust nozzle
► Fig.22: 1. Support 2. Lock lever
1.
Raise the lock lever of the dust nozzle.
2.
Place the dust nozzle onto the tool base so that its
top will be caught in the hook on the tool base.
3.
Insert the supports on the dust nozzle into the
hooks on the front of the tool base.
4.
Push down the lock lever onto the tool base.
5.
Connect a vacuum cleaner to the dust nozzle.
► Fig.23
Removing the dust nozzle
1.
Raise the lock lever.
2.
Pull the dust nozzle out of the tool base while
holding the supports between thumb and finger.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Replacing carbon brushes
► Fig.24: 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1.
Use a screwdriver to remove the brush holder
caps.
2.
Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
► Fig.25: 1. Brush holder cap
For tool with the knob
CAUTION:
Be sure to re-install the knob after
inserting new carbon brush.
Release the lock lever and remove the knob by turning
it counterclockwise.
► Fig.26: 1. Knob
NOTE: The compression spring will come out of
the knob, so be careful not to lose the compression
spring.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
Router bits
Straight bit
► Fig.27
D
6
1/4"
12
1/2"
12
1/2"
8
6
1/4"
6
1/4"
"U"Grooving bit
► Fig.28
D
A
6
6
"V"Grooving bit
► Fig.29
D
A
1/4"
20
12 ENGLISH
A
L1
20
50
12
60
10
60
8
60
8
50
6
50
L1
L2
50
18
L1
L2
50
15
Unit:mm
L2
15
30
25
25
18
18
Unit:mm
R
3
Unit:mm
θ
90°
Publicité
Table des Matières
