The Licenseplateholder - Pro-User DIAMANT I Notice D'assemblage Et De Sécurité

Now test if the carrier is attached steady enough on the tow ball (and not easy to
twist). If not, you have to adjust the quick connector. If it is not tight enough,
take the carrier off again and screw in the adjustment screw of the quick
connector a little bit further. Loosen locking nut first, screw in adjustment screw
and tighten locking nut again.
Check again if the carrier is properly secured to the tow ball (and cannot rotate
easily). Repeat this until the carrier is properly secured.
Caution: Always make sure that the locking nut of the adjustment bolt is
tightened again!
When the bike carrier is not easy to turn anymore, the quick connector can be
locked. Lock the quick connector with the locking/safety slide and lock and take
the key out. Keep the key carefully on a safe place. The bike carrier is now also
protected against theft.
Always check if the quick connector is well secured with the
locking/safety slide and is locked. The carrier may never be
used if it is not secured and locked.

THE LICENSEPLATEHOLDER

The clips (2) to mount the
license plate can be
pressed out and are in the
license plate holder (see
image).
33