Pro-User DIAMANT I Notice D'assemblage Et De Sécurité page 31

M6x30, washers M6 and M6 wingnuts.
Slide the U-frame against the outside
of the U-frame holders of the base
frame. Secure this U-frame with the
supplied carriage bolts (M8x60),
washers and plastic rotary knobs.
Make sure the plastic rotary knobs
are on the inside (see picture).
Please note: firmly tighten both
rotary knobs so that the U-frame will
come on its place well.
Loosen and remove the little screws
intended for the mounting of the
number plate holder from the light
holder rail and fasten the number
plate holder to the rail. The number
plate holder has to be level with (or
just above) the lighting.
With the cable ties supplied with the
carrier, the light cable can be fastened
neatly at the bottom of the carrier.
Put the wheel holder bar on the base
frame of the bike carrier with the
holes right above the holes in the
base frame. Then attach the wheel
holders with the four T-bolts (slide
into the bottom of the rail and place
the end cap in the rail end) M6x50,
Unscrew the plastic rotary head of the
frame holder, so the clamp can be
folded open. Put the clamp around the
U-frame, subsequently re-attach the
holder and screw the plastic rotary
head until you can just turn the frame
holder (the frame of the bike has to
be attached to it, so it has to be
movable). The side with the strap is
intended to fasten the bike.
31