Thermostat Mounting - Honeywell Home RLV4305A1014 Manuel Du Propriétaire

Wiring
Connect the thermostat wires to the power and to the load using solderless
connectors for copper wires.

Thermostat mounting

1. Push the excess wires back inside the electrical
box.
2. Secure the thermostat to the electrical box using
the provided screws.
3. Insert the screws through either the right or left
pair of mounting holes on the thermostat.
NOTE: If there is a protective film or sticker on the
thermostat's screen, peel it off.
4. Apply power to the heating system. Verify the
installation by checking that the heater can be
turned on by raising the setpoint using the Up button
and off by lowering the setpoint using the Down button.
WARNING
Keep the thermostat's air vents clean and free
from obstructions.
2-wire Installation 4-wire Installation
3
M38834
M38835