Orbegozo WF 0250 Manuel D'instructions page 9

WF 0250
distortion of fan body and cause electrical hazards.
• Keep away from curtain, clothing or other something
may affect the fan's working.
• Turn off all switches and pull out power supply plug
when you go out for long time.
• Never use the fan before finishing assembly to avoid any
hurts.
• Disconnect plug when removing guards for cleaning.
ASSEMBLE AND USE
Assemble the back cover
- Attach the back cover to the motor by fastener
- Be careful about the rotation of the fan blade.
- Fix the cover ring to the back cover by placing the channel of the cover ring around the circumference of
the back cover.
-Tight the screw half way to avoid unnecessary movement while assemble the fan blades.
Attach the fan blades
- While installing the fan blades insert the opening on the back of the fan blade inside the spacer pin of the
motor shaft of the motor.
- Fasten the Fastener for Fan blade
Assemble the Front Cover
-Attach the circumference of the front cover inside the other channel of the covering ring.
- Finally tight and secure the screw of the covering ring.
INDICATIONS
- This fan can tilt upwards and downwards by turning and let loose the joint knob . It is important to re-
secure this knob after you adjust the settings.
- To operate the fan and increase the speed, use the right handle
- To turn it off and / or decrease the speed use the left handle
9