Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Switching the cooking zones on
To switch on a cooking zone press the cor-
responding Cooking Zone key then adjust
the heat setting using the [+] key and [-]
Key within 10 seconds. The heat level of
each single cooking zone can be set in 9
different positions and will be shown in the
corresponding cooking zone display with a
number ranging from «1» to «9». Press the
[+] key to increase the heat level, press the
[-] key to decrease it.
• Switching the cooking zones off
To switch a cooking zone off select it and
bring its heat level back to «0» by pressing
the [-] key.
0 4
• Pot detection «
Each induction cooking zone has a pot de-
tection minimum limit, which
varies according to the material of the co-
okware being used.
For this reason, you should choose the
cooking zone which is most suitable for the
diameter of the cookware you are going to
use.
0 4
If the symbol «
» appears on the co-
oking zone display, it means that:
• The cookware used is not suitable for
induction cooking.
• The cookware diameter is smaller than the
one allowed by the hob.
• No cookware is on the cooking zone.
For more details about this feature refer to
chapter ''Induction cooking".
• Residual heat «H»
If the temperature of the cooking zone is
still high (over 50°) after it has been swi-
tched off, the relative display will indicate
the symbol «H» (residual heat).
The symbol will stay on even when the
appliance is switched off and will only switch
off when the burn risk in no longer present.
»
• Power Boost «P»
The use of this function is recommended
for heating large quantities of liquids (e.g.
water to cook pasta) or food in a very short
time.
This program further reduces the cooking
time of a certain cooking zone, by bringing
the temperature to the maximum heat level
for 10 minutes.
At the end of this timeframe, the cooking
zone heat level will automatically go back to
level «9». To activate this program, switch on
the cooking zone B1 or B4 and press the [+]
key until you reach level «9» then press the
[+] key again. The «P» symbol will be shown
on the cooking zone display to confirm the
activation of the function.
• Timer
This function allows you to set the time from
«01» (1 minute) to «99» (99 minutes) for the
automatic switch off of a cooking zone.
Select a cooking zone by pressing the cor-
responding Zone Selection key and adjust
the heat level. Press simultaneously the [+]
and [-] keys to activate the Timer display.
Set the desired time within 10 seconds using
the [+] and [-] keys. Wait 10 seconds for the
automatic confirmation of the settings. The
time countdown will be shown on the timer
display.
When time elapses the cooking zone will au-
tomatically switch off, the display will show
a flashing «00» and an acoustic signal will be
heard. Press any key on the control panel to
stop the signals.
To disable the timer of a cooking zone press
the corresponding Zone Selection key then
press simoultaneously the [+] and [-] keys
to turn on the Timer display. Bring the timer
value back to «00» by using the [-] key. Wait
10 seconds for the automatic confirmation.
The led (C*) on the display of the cooking
zone stops flashing.
• Egg timer/reminder
When no cooking zone is active it is possi
14
Publicité
Table des Matières
