Care And Maintenance; Cleaning Your Wine Chiller; Power Failure; Reversing The Door Swing Of Your Appliance - Avanti Designer WCF143S3ST Manuel D'instructions

Ø CLEANING YOUR WINE CHILLER
·
Turn off the power, unplug the appliance, and remove all items including shelves.
·
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
·
Wash the shelves with a mild detergent solution.
·
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
·
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
·
Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
Ø POWER FAILURE
·
Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps to protect your contents.
Ø REVERSING THE DOOR SWING OF YOUR APPIANCE
·
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please call customer service for reversal instructions.
Ø MOVING YOUR WINE CHILLER
·
Remove all items.
·
Securely tape down all loose items (shelves) inside your appliance.
·
Tape the door shut.
·
Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
Ø ENERGY SAVING TIPS
·
The Wine Chiller should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.

CHARCOAL FILTRATION SYSTEM

Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality
and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions.
Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency,
and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located
at the rear panel inside your cellar.
Keep in mind, that this filter must be changed every 12 months.
To purchase replacement filters, call our Parts / Service Department at 1 – 800 – 220 – 5570.
To replace your filter:
1 Remove the bottles of wine stored on the two (2)
shelves in front of the filter.
2 Remove the shelves and set aside to be replaced
once you have changed the filter
3 Hold the filter and turn it at 45 degrees in the
counter-clockwise direction and then pull it out.
4 Remove the existing filter and replace with a new
one.
5 Put the new filter into the hole and then turn the filter
at 45 degrees in clockwise direction.

CARE AND MAINTENANCE

12
Turn Left to remove filter.