Samsung WW10K64 Serie Manuel D'utilisation page 51

Code
HC
1C
8C
AC
AC6
DDC
If any information code keeps appearing on the screen, contact a local Samsung service
centre.
WW10K6410QX_DC68-03676Y-00_EN.indd 51
High temperature heating check
• If the information code remains, contact a customer service
centre.
The Water Level sensor is not working properly.
• Try power off and restarting the cycle.
Check WaterLevel Sensor wire harness.
•
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the "1C" code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
If the information code remains, contact a customer service
•
centre.
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service
centre.
Check communications between main and inverter PBAs.
• Depending on the state, the machine may automatically returns
to normal operation.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
This message appears when you open the Add Door without
pressing Pause. If this happens, do one of the following:
• To add laundry, press the Add Door to close it properly. Then,
press Start/Pause and try again.
• If you press the Add Door by mistake, press the Add Door
again to close it properly. Then, press Start/Pause to resume
operation.
Action
English 51
2017/5/16 10:49:29