Tripp-Lite PDUMH30NET Serie Manuel Du Propriétaire page 6

Features
STATUS CONFIG RESET
21-03-423-933686.indb 6 21-03-423-933686.indb 6
Output Circuit Breakers: Two circuit breakers (one per
outlet bank) protect connected equipment against
dangerous system overloads. If the total load on either of
the PDU's outlet banks exceeds 20 amps (PDUMH30NET
& PDUMH32HVNET) or 15 amps (PDUMH30HVNET), the
associated circuit breaker will trip, cutting power to the
entire outlet bank. Reduce the load on the outlet bank by
unplugging some equipment, then press the circuit
breaker in/set to the ON position to restore power.
Cord Retention Shelves (Optional): When installed on
the PDU, these shelves provide secure attachment points
for connected equipment power cords. Use the included
cable ties to secure cords to the shelf.
C14 Plug-Lock Insert Sleeve (Optional): Use the
included plastic sleeves to secure C13 power cords to
C14 inlets. Fit the sleeve over the end of the cord,
making sure the pull-tabs remain outside the cord and
the fit is secure. To unplug equipment properly, grip both
the cord and the insert's tabs at the same time and pull.
C20 Plug-Lock Insert Sleeve (Optional): Use the
included plastic sleeves to secure C19 power cords to
C20 inlets. Fit the sleeve over the end of the cord,
making sure the pull-tabs remain outside the cord and
the fit is secure. To unplug equipment properly, grip both
the cord and the insert's tabs at the same time and pull.
Mounting Brackets: These detachable brackets enable
the PDU to be installed in a 2U rackmount configuration
or an under-counter configuration.
Factory Port: The port is reserved for configuration by
factory authorized personnel only. Do not connect
anything to the port.
Ground Connection: Use this to connect any equipment
that requires a chassis ground.
WEBCARDLX: Allows you to operate this PDU as a
managed network device, accessible via SNMP network
management platform, web browser, SSH or Telnet.
6
4/5/2021 1:57:32 PM 4/5/2021 1:57:32 PM