Blue Clean AR390 Instructions D'opération page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions and Parts List
Never disconnect the high
pressure discharge hose from
the machine while the system
is pressurized. To depressurize
machine, turn power and water
supply off, then press gun
trigger 2 - 3 times.
Never permanently engage the
trigger mechanism on the gun.
Never operate the machine
without all components
properly connected to the
machine (handle, gun/wand
assembly, nozzle, etc.).
ALWAYS turn water supply
"ON" before turning pressure
washer "ON". Running pump
dry causes serious damage.
Do not operate the pressure
washer with the inlet water
screen removed. Keep screen
clear of debris and sediment.
NEVER operate pressure washer
with broken or missing parts.
Check equipment regularly
and repair or replace worn or
damaged parts immediately.
Use only the nozzle supplied
with this machine.
Never leave the wand
unattended while the machine
is running.
Never attempt to alter factory
settings. Altering factory
settings could damage the unit
and will void the warranty.
Always hold gun and wand
firmly when starting and
operating the machine.
NEVER allow the unit to run
with the trigger release (off)
for more than one (1) minute.
Equipment
damage.
Resulting heat buildup will
damage pump.
Pressure washer is not meant
to pump hot water. NEVER
connect it to a hot water supply
as it will significantly reduce the
life of the pump.
NEVER store the pressure
washer outdoors or where it
could freeze. The pump will be
seriously damaged.
Release trigger when changing
from high to low pressure
modes. Failure to do so could
result in damage.
objects. Bursting hoses may cause
injury. Examine hoses regularly
and replace if damaged. Do not
attempt to mend a damaged hose.
o
PeratinG
1. Install high pressure hose to
gun.
5
AR390
Keep hose away
from sharp
i
nStrUctionS
www.arblueclean.com

Publicité

Table des Matières
loading

Table des Matières