Blue Clean AR390 Instructions D'opération page 3

Operating Instructions and Parts List
i S
MPortant afety
S T
ave heSe
When using this product, basic
precautions should always be
followed, including the following:
1. Read all instructions before
using the product.
2. Always disconnect power
before disassembling or
repairing the unit.
3. Follow all safety codes as well
as the Occupational Safety and
Health Act (OSHA).
4. Ensure safety devices are
operating properly before each
use. DO NOT remove or modify
any part of the gun or unit.
5. Know how to stop this product
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
6. Stay alert - watch what you are
doing.
7. Do not operate the product
when fatigued or under the
influence of alcohol or drugs.
8. Keep operation area clear of all
persons.
9. Do not overreach or stand on
unstable support. Keep good
footing and balance at all
times.
10. Follow the maintenance
instructions specified in the
manual.
11. This product is provided with a
ground fault circuit interrupter,
GFCI, be sure to inspect cord
and GFCI prior to use. Any
repair or replacement of the
power cord must be performed
by a qualified (licensed or
i
nStrUctionS
I
nSTrucTIonS
certified) electrical technician.
12. Never use an extension cord
with this product.
13. To reduce the risk of injury,
close supervision is necessary
when a product is used near
children.
• Inspect cord before using - Do
not use if cord is damaged.
• Keep all electrical connections
dry and off the ground.
• Do not touch plug with wet
hands.
• This product is provided with a
ground fault circuit interrupter
built into the power cord plug.
If replacement of the plug
or cord is needed, use only
identical replacement parts.
• Do not spray electrical
apparatus and wiring.
• High pressure. Keep clear
of nozzle. Do not discharge
streams at persons or animals.
• Never put hand or fingers over
spray tip while operating the
unit.
• Never try to stop or deflect
leaks with any body part.
• Always engage the trigger
safety latch in the safe position
when spraying is stopped even
if only for a few moments.
• Point gun in safe direction.
Unit will start spraying when
trigger is squeezed if 'on/off'
switch is in "ON" position.
• Discharge pressure - When 'on/
3
AR390
Risk of
Electrocution
Risk of Injection
or Severe Injury
www.arblueclean.com