DeWalt DCCS690 Guide D'utilisation page 17

Saw chain and Guide Bar oiling (fig. 12)
Auto oiling System
This chain saw is equipped with an auto oiling system that keeps the
saw chain and guide bar constantly lubricated. The oil level indicator
(I) shows the level of the oil in the chain saw. If the oil level is less than
a quarter full, remove the battery from the chain saw and refill with
the correct type of oil. Always empty oil tank when finished cutting.
note:
Use a high quality bar and chain oil for proper chain and
bar lubrication. As a temporary substitute, a non-detergent SAE30
weight motor oil can be used. The use of a vegetable based bar
and chain oil is recommended when pruning trees. Mineral oil is not
recommended because it may harm trees. Never use waste oil or
very thick oil. These may damage your chain saw.
filling the oil reservoir
• Flip down locking lever and
unscrew counterclockwise a
quarter turn and then remove
the oil cap (P). Fill the reservoir
with the recommended bar and
chain oil until the oil level has
reached the top of the oil level
indicator (I).
• Refit the oil cap and tighten
clockwise a quarter turn. Flip
up locking lever to its locked
position.
• Periodically switch the chain saw off and check the oil level
indicator to ensure the bar and chain are being properly oiled.
All manuals and user guides at all-guides.com
FIG. 12
I
P
15
Transporting Saw (fig. 13)
• Always remove the battery from the tool and cover the guide bar
(D) with the scabbard (J) (figure 13) when transporting the saw.
• Engage chain brake by pushing chain brake / front hand guard (C) forward.
FIG. 13
operating the chain Saw (fig. 14-15)
WARNING:
instructions. Failure to follow all instructions listed below may result
in electric shock, fire and/or serious personal injury.
• Guard Against Kickback which can result in severe injury
or death. See important Safety instructions "Guard Against
Kickback", to avoid the risk of kickback.
• Do not overreach. Do not cut above chest height. Make
sure your footing is firm. Keep feet apart. Divide your weight
evenly on both feet.
• Use a firm grip with your left hand on the front handle (L)
and your right hand on the rear handle (K) so that your body
is to the left of the guide bar.
• Do not hold chain saw by front hand guard/ chain brake
(C). Keep elbow of left arm locked so that left arm is straight to
withstand a kickback.
WARNING:
Never use a cross-handed grip (left
hand on the rear handle and right hand on the front handle).
WARNING:
Never allow any part of your body
to be in line with the guide bar (D) when operating the chain saw.
• Never operate while in a tree, in any awkward position or
r e a d a n d u n d e r s t a n d a l l