Important Safety Instructions For All Battery Chargers - DeWalt DCCS690 Guide D'utilisation

Scie á chaíne de litho
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

to your local retailer for recycling. You may also contact your local
recycling center for information on where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery
Recycling Corporation.
important Safety instructions for All
Battery chargers
SAvE THESE INSTRUCTIONS: This manual contains important
safety and operating instructions for battery chargers.
• Before using the charger, read all instructions and cautionary markings
on the charger, battery pack and product using the battery pack.
WARNING:
Shock hazard. Do not allow any liquid to
get inside the charger. Electric shock may result.
CAUTION:
Burn hazard. To reduce the risk of injury,
charge only D
WALT rechargeable battery packs. Other types of
e
batteries may overheat and burst resulting in personal injury and
property damage.
NOTICE: Under certain conditions, with the charger plugged into the
power supply, the charger can be shorted by foreign material. Foreign
materials of a conductive nature, such as, but not limited to, grinding
dust, metal chips, steel wool, aluminum foil or any buildup of metallic
particles should be kept away from the charger cavities. Always unplug
the charger from the power supply when there is no battery pack in the
cavity. Unplug the charger before attempting to clean.
• DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The charger and
battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging D
WALT rechargeable batteries. Any other uses may
e
result in risk of fire, electric shock or electrocution.
All manuals and user guides at all-guides.com
• Do not expose the charger to rain or snow.
• Pull by the plug rather than the cord when disconnecting the
• Make sure that the cord is located so that it will not be
• Do not use an extension cord unless it is absolutely
• When operating a charger outdoors, always provide a dry
• An extension cord must have adequate wire size (AWG or
Ampere Rating
More
than
10
12
9
charger. This will reduce the risk of damage to the electric plug and cord.
stepped on, tripped over or otherwise subjected to damage
or stress.
necessary. Use of improper extension cord could result in risk of
fire, electric shock or electrocution.
location and use an extension cord suitable for outdoor use. Use
of a cord suitable for outdoor use reduces the risk of electric shock.
American Wire Gauge) for safety. The smaller the gauge number
of the wire, the greater the capacity of the cable, that is, 16 gauge
has more capacity than 18 gauge. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating. When
using more than one extension to make up the total length, be sure
each individual extension contains at least the minimum wire size.
The following table shows the correct size to use depending on cord
length and nameplate ampere rating. If in doubt, use the next heavier
gauge. The lower the gauge number, the heavier the cord.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet (meters)
120V
25 (7.6)
240V 50 (15.2) 100 (30.5)
not More
than
0
6
18
6
10
18
12
16
16
14
50 (15.2)
100 (30.5) 150 (45.7)
200 (61.0) 300 (91.4)
aWG
16
16
14
16
14
12
16
14
12
12
Not Recommended

Publicité

Table des Matières
loading

Table des Matières