Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Removing/inserting the dust bin
•
Removal: Push the release button on the dust
bin and take it out of the device by the handle.
•
Insertion: Take the dust bin by the handle and
first place the bottom of the bin in the device
(the bottom is facing down and handle is facing
up). Then push the handle against the device
housing until the dust bin audibly locks into
place. Hold the device by the handle and lift it to check whether the dust bin is
properly seated.
Operation
ATTENTION!
•
During use, always keep the nozzles away from body parts and animals and
do not reach into them. You could be caught or injured. If something does
get caught in the vacuum cleaner, turn it off immediately (depress the On/Off
switch).
•
Only turn on the vacuum cleaner once you are sure that all parts have been com-
pletely mounted and that the dust bin, dust filter and the exhaust filter have been
properly inserted.
•
To prevent the cord from becoming too hot when in use, pull at least two thirds
of its entire length out of the device before you switch on the vacuum cleaner.
Do not forcefully pull out the cord up to the stop point (no further than up to the
red mark on the cord) in order to prevent damage!
•
Always turn off the device first and pull the mains plug out of the socket before
you change a nozzle or attach or remove other accessories!
•
Do not in any circumstances vacuum up the following:
– Liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– flammable or ignitable materials
– very fine dust (e.g. cement dust), ash or toner
– hard, pointy objects such as bigger glass shards
22
Publicité
Table des Matières
