Monster iSport FREEDOM Mode D'emploi page 3

Physiology of the Ear and Hearing
Incus
Malleus
Auditory Canal
Tympanic
Membrane
Stapes
For additional information on what loud noises do to your ear and chart reference www.
abelard.org/hear/hear.php#loud-music
Use Responsibly
Do not use headphones when it's unsafe to do so—while operating
a vehicle, riding a bike, crossing streets, or during any activity or
in an environment where your full attention to your surroundings
is required.
It's dangerous to drive while wearing headphones, and in many
places, illegal because it decreases your chances of hearing life-
saving sounds outside of your vehicle, such as another car's horn
and emergency vehicle sirens.
Please avoid wearing your headphones while driving. Use one
of Monster's FM transmitters to listen to your mobile media
devices instead.
Cleaning
Wipe earcups with a soft cloth dampened with a mild soap solution.
Keys and Parts
1
2
3
4
8
9
The headset contains the following parts:
1. Multifunction key
(Power On/Off, Pairing,
Activate Voice Dialing)
2. Track back
3. Volume down
4. Indicator light
(Only visible when lit)
Cochlear Nerve
Cochlea
Vestibule
To Nose/Throat
10
5. Play / Pause key
(Answer/End/Reject Call)
6. Track forward
7. Volume up
8. Charger connect
9. 3.5mm cable port
10. Microphone
Before using the headset, you must charge the battery and pair the
headset with a compatible device. Freedom will function without a
charged battery when attached by cable to phone or music player.
Charge the Battery
The headphone includes a Micro USB cable that can be connected
to your computer or other device made for USB charging. Plug the
Micro USB end of the included USB cable into the USB micro port
charger connector under the left earcup of the headphone. Plug the
other end into a USB port on your computer or other devices made
for USB charging. The indicator light will be red while charging. Once
fully charged, the green LED will be on. Charge time is 1.5 hours
on an empty battery. The fully charged battery has power for up to
10 hours talking and/or music time and up to 100 hours standby time.
WARNING: (1) Please pay attention to the environmental aspects of
battery disposal. Battery must be recycled or disposed of properly.
This product must not be disposed together with the domestic
waste. This product has to be disposed at an authorized place for
recycling of electrical and electronic appliances. By collecting and
recycling waste, you help save natural resources, and make sure the
product is disposed in an environmental friendly and healthy way. (2)
Batteries (battery pack or batteries installed) should not be exposed
to excessive heat, such as sunshine, fire, or the like. (3) DO NOT
disassemble or replace the battery. If you suspect there is something
wrong with the battery, please carry the unit to the service center
for help.
Switch On
To switch on, press and hold the multifunction key about two
seconds. The headset beeps ascending tones, and the green
indicator light is briefly displayed. When the headset tries to
connect to the last used phone or music player, the red indicator
light flashes slowly. When the headset is connected to a device
and is ready for use, the blue indicator light flashes slowly. If the
headset has not been paired with a device, it automatically enters
the pairing mode.
5
Switch Off
To switch off, press and hold the multifunction key for about three
seconds. The headset beeps descending tones, and the red light is
briefly displayed. If the headset is not connected to a device within
6
10 minutes, it switches off automatically.
Pairing
1. Ensure that your phone or music player is switched on.
7
2. To pair the headset if it has not been previously paired with a
device, switch on the headset. The headset enters the pairing
mode, and the blue and red indicator light starts to flash quickly.
To pair the headset if it has been previously paired with another
device, ensure that the headset is switched off, and press and
hold the multifunction key (for about five seconds) until the blue
and red indicator light starts to flash quickly.
3. Activate the Bluetooth
and set it to search for Bluetooth devices.
4. Select "Freedom" from the list of found devices on your phone
or music player.
5. If necessary, enter passcode 0000 to pair and connect the
headset to your device.
Adjust the Volume
To adjust the headset volume, press the volume up or down key
during a call or while listening to music. To adjust the volume
quickly, press and hold either key.
WARNING: Excessive sound pressure from earphones and
headphones can cause hearing loss.
Calls
To make a call, use your mobile phone in the normal way when the
headset is connected to it.
feature on your phone or music player,
®