Tools Needed For Assembly - Kimex 013-4040 Instructions De Montage

THE WARRANTY WILL ONLY BE VALID IF YOU FOLLOW THE INSTRUCTIONS CAREFULLY.
Please do not begin installation until you have thoroughly read and understood these instructions.
Improper installation may cause serious injury and/or damage. It is recommended that a qualified contractor
install the 013-4040 In Wall Mount.
Make sure that the wall you plan to use will safely support four times the combined weight of the
mounted equipment, including its accessories. Warranty will be void if TV Mount is not installed
to wood studs or masonry.
The 013-4040 In Wall Mount supports LED, LCD, and Plasma Flat Panel Displays a maximum load of 36.4
kg( 80 lbs).
This products suits displays with mounting hole patterns from 100mmx100mm, 200x100mm,
200x 200mm .
A second person will be required to assist with several steps.
The manufacturer does not accept responsibility for incorrect installation.

Tools Needed for Assembly

• Stud finder ("edge to edge" stud finder is recommended)
• Phillips screwdriver
• Pencil
• Hammer Drill(Concrete installation only)
• 5/32" drill bit for wood studs, 5/16" drill bit for concrete
• 3/8" socket wrench or bit driver for wood screws
• Level
• Tape measure
Mount Arm assy(x1)
Lag Bolt
6*50mm(x5)
Spacer (x4)
WARNING
!
Adapter plate (x1)
Metal washer
diameter 6 (x4)
5mm Allen Key (x1)
M4x16mm (x4 each)
M5x16mm (x4 each)
M6x16mm (x4 each)
Nut M8(x4)
6mm Allen Key (x1)
M8x16mm (x4 each)
M8x35mm (x4 each)
2 of 7
In-wall Box (x1)
Metal washer
diameter 8 (x4)
Open-end wrench(x1)