Kimex 013-4040 Instructions De Montage page 14

St ep 5
Swivel - Adjust the flat panel display for off center viewing positions.
Grasp the side edges of the display and then swivel display into its desired
position (Fig.11).
Panning - Positions the flat panel display at an angle to the wall for viewing
from opposite sides of the room.
Grasp the side edges of the display and then swivel and pull the display
into desired position (Fig.12).
Retracting the Flat Panel Display
Grasp the side edge of the display, swivel and pull the display into the center
position (Fig.13), and then gently push the display straight back towards the
wall into the retracted position (Fig.14).
Note:
Use care when moving the display to ensure tha t cables do not
become stretched or pinched.
It is suggest allowing a small amount of slack in cables to allow
for easy movement withou t pinching .
Maintaining the
The arm assembly and wall plate may be cleaned with a soft sponge and mild solution of soap
and water.
Caution : Be sure not to get moisture on the electrical connections or the display.
- Positions the display against the wall.
013-4040 Universa l
Cantilever Mount
7 of 7
Fig.11
Fig.12
Fig.13
Fig.14