Kimex 013-4040 Instructions De Montage page 11

Step2 Mounting the mount arm assy
Align the hole pattern on interior mounting plate of in-wall box with hole pattern
on the wall plate of mount arm assy.
NOTE: Consider position of display center or routing of cables before securing
arm to in-wall box.
Drill two 5/32" (4 mm) holes 2" (50 mm) deep using interior mounting plate holes
of in-wall box as a guide
Attach the mount arm assy to in wall box using two lag bolt 6x50mm wood screws
Notes:
We do not recommend using a drill driver or impact wrench to tighten bolts.
Tighten lag bolts so that wall plate is firmly attached to wall,but DO NOT over tighten.
The lag bolts can be damaged by over tightening which will strip their threading.
Final tightening of lag bolts should be done by hand using a ratchet wrench and socket.
.
-
Lag bolt
6x50mm
Wall plate
4 of 7
.