Adjusting The Display - Kimex 013-4040 Instructions De Montage

Using Cable Management
Step 5
The 013-4040 includes a cable management system where
cable can be routed along the length of the arm assembly.
For optional installation of electrical gang box, access plates
located on the bottom or top of in-wall box can be
temporarily removed to install electrical gang box
as shown in fig6.
Route the display cable along the entrance of the cable
management slot.(Fig.6)
Note: For optimal performance, route the AC power
cable separately from the audio and video cables.
With all cables in place, pull the display in and out to
be certain that the arm assembly moves freely, without
stretching or damaging the cables.
Step6

Adjusting the Display

The 013-4040 provides a wide range of adjustment possibilities to suit your environment.
Roll Control - Horizontal leveling of the flat panel display.
Grasp the edge of the display and roll it up or down into a level position (Fig.7.1).
Tilt Adjustment - Raising or lowering the screen to improve viewing angle.
First release completely the tilt knob as shown(Fig.9)
Second Grasp the upper and lower edges of the display, and then turn
it to the desired tilt angle(Fig.8).
To lock the tilt angle, tighten the tilt knob (Fig.10) securely.
NOTE: For heavier displays, never fully release the tilt knob without
fully supporting the display.
The tilt lever includes a ratchet function, so that it can be lifted and
repositioned for the next turn. To operate the ratchet, pull the lever
straight out, rotate it to an unobstructed position, release the lever,
and then turn it in the desired direction. Repeat as necessary until
the tilt tension is set properly (Fig.10)
Fig.7.2
Fig.8
Cable
Fig.6
Loosen the screws as shown in
Fig. 7.2 to allow roll control adjustment.
Tighten screws by hand when finished.
Tilt knob
Turn
6 of 7
U-Cap Cable
Access
Management
Plate
Fig.7.1
Fig.9
Release tilt knob
a
c
Fig.10
Access
Plate
b
Tighten
d