Final Check-List - kiwy SLF 123 Manuel D'instructions

Check that both Isofix connectors are properly a ached to the Isofix
anchor points.
Sit the child into the child car seat and fasten the safety belt, following
the indica ons of Fig. 25.
Make sure that the diagonal vehicle seat belt sec on passes through
the upper belt guide and over the child's shoulder, but does not
touch his/her neck.
Tighten the diagonal sec on of the safety belt by pulling in an
upward direc on, un l it adheres correctly and the child car seat is
safely fixed onto the car seat.
To reach the right belt posi on, you can easily adjust the backrest
height by following the opera ons in Fig.20.
Always check that the car safety belt is not twisted, and then tension
it, pulling the diagonal sec on in an upward direc on.
Always check that the excess length of the safety belt is retracted by
accompanying the diagonal sec on of the belt in an upward direc on.
Notes: To be er protect your child:
. Make sure your child is securely fastened in the safety seat and the
harness snugly fits over his/her body.
. Never leave your child una ended in the safety seat or in the
vehicle.
. When installing your child on the rear seat of the vehicle, move the
front seat forward far enough to avoid his feet hi ng the backrest of
the front seat (this may also prevent risk of injury, in the case of an
accident).
. When entering in or exi ng your child from the vehicle, do it only on
the safe side of the street, away from traffic.
V. Final Check-list
1 Always check the height of the shoulder straps and make sure they
are correctly adjusted at the same
level of the shoulders or slightly above.
2 Check that both Isofix connectors are properly a ached to the
9