Power Supply - Nordica WANDA Instructions Pour L'installation, L'utilisation Et L'entretien

POWER SUPPLY

230V 50/60Hz.
TM=MINIMUM THERMOSTAT
The COMMAND must be connected to the mains with a differential line cut-off switch according to the regulations in force. Correct operation of the command is
assured only for the proper motor for which it has been manufactured. Improper use relieves the manufacturer from each responsibility
0020800
Code 0020800 PACKAGED UNIT CONTROLLER
CONSOLE OPERATION:
This electronic controller for packaged units manages ventilation air flows.
The controller is switched on or off by pressing and holding the
During operation the display shows the set speed alternating with unit status.
When the unit is off, the display also remains off.
The unit can be controlled manually or automatically.
To access Manual mode, press the
function is active. The
also active when the flue is cold.
The motor is started in automatic mode by a mechanical thermostat (the display
shows WAIT), which is activated when the temperature is at least 45° C (fixed
value, not modifiable).
The
To access Automatic mode, press the
the function is active. Use the
The
mode the COMFORT temperature can also be selected.
Press the
the value using
room temperature measured by the probe inside the controller exceeds the
comfort set point; the motor operates one speed lower (this mode has no effect in
first speed) and is signalled by the
Pressing and holding the
display language can be changed using the
Pressing the
brightness can be adjusted (between 10 and 150). Pressing the
briefly another time accesses the degrees menu, where the temperature display
can be set as ° C or ° F.
Pressing the
audible buzzer can be enabled or disabled.
N POWER SUPPLY
Ph POWER SUPPLY
N FAN
01 FAN
= FAN
buttons are used to select one of the five fan speeds,
LED indicates that the thermostat contact is closed.
Ok
button to set the speed.
buttons are used to select one of the five fan speeds. In automatic
button to access the COMFORT temperature setting and then set
.
This setting allows the user to reduce fan noise when the
/A
button accesses the language menu, where the
/A
button briefly again accesses the display menu, where the
/A
button briefly a final time accesses the buzzer menu, where
Neutral Colour:
Phase Colour:
Neutral Colour:
Out 1 Colour:
Earth Colour: Yellow-green
NOTA:
Pag. 3
button.
/A
button; when the light comes on the
/A A
button; when the light comes on
, buttons (IT, EN, DE, FR).
Blue
Brown
Blue
Brown
EN
| | | |
/A
button