Replacing The Filters - Turin Aspen Manuel D'installation, D'utilisation Et D'entretien

12. Replacing the LED light
Do not touch lamps during or soon after operation. Burns may occur. Only use the LED light replacements available
separately from Turin.
LED LIGHT BULB: USA/Canada: 1.SW LED (please refer to the actual specification of the hood purchased)
1. Make sure the range hood is unplugged or turn off breaker.
2. Pop out the light by pressing behind the light fixture.
3. Put the new light bulb set back by pressing it in.
4. Plug in the range hood to test operation.

13. Replacing the filters

Always replace damaged filter that has punctured or broken mesh, bent or broken frame.
Should filters wear out due to age, damage and/or prolonged use, please visit www.myturin.com to find new
replacement filters adapted to your unit model.
1. Make sure the waste oil container is inside the hood body slot;
2. The container must be upward and the smaller side in front.
3. Angle at higher point the filter toward the waste oil container side.
4. Lift the lower angle of the filter up above horizontal level.
5. Slide backward into the slot.
To remove, please reverse the process.
16
WARNING
WARNING