Muuwmi 464 Mode D'emploi page 5

EN Owner's manual
Dear customer,
Congratulations on the purchase of this product.
Please take note of the following points, in order to ensure the con-
tinued enjoyment of this product. Please read this owner's manual
carefully before use. The owner's manual as well as the packaging
are a constituent part of the product. Both should be stored for
future issues. This product is not intended for commercial use. The
use requires specific knowledge and skills. The product should only
be made available to a user of the appropriate age and should only
be used for its intended purpose. The assembly has to be carried
out by an adult.
Technical product specifications
Article: Aluminium Scooter Muuwmi AIR 205mm
Article number: 464
Userweight: 35 - 100 kg
Product dimensions: 90 x 34 x 97,5 cm
Content
1 x Scooter
2 x tool
1 x owner's manual
Other parts serve as transport protection and are not required for the
assembly and use of the article.
Assembly instructions for folding-out and folding-in the scooter
• The scooter may only be folded-out or else folded-in, by just one
person.
• Caution: Be careful that you do not pinch your fingers in the hinges
or latches.
• The locks must be locked into place and the quick-release lever
securely closed.
• Manual Muuwmi AIR inflate the tire.
Inflate the tyres
Note: The tyres of the Scooter are due to transport conditions, only
inflated to 50% with air. The tyres should be inflated as described
below prior to the first use.
The tyre pressure may not exceed a maximum of 2,5 bar. Exceeding
the aforementioned value can lead to bursting of the tyre or damage
to the rim.
Pictures are
design examples.
1. Turn off the valve cap.
2. Place a commercially available car tyre pump on the valve and
inflate the tyre up to the ideal air pressure.
3. Close the valve cap. Ensure that the valve cap is tightly closed.
4. Please check the tire pressure prior to each use and, if necessary,
inflate with air. Ride comfort and ride speed are strongly dependent
on the tire pressure. We recommend the specified tire pressure of
max. 2 - 2,5 bar.
Folding-out the scooter
Open the quick-release lever.
Pull the internal plastic slider upwards until the axle of the quick
release locking system is released from the mount.
Folding-out the handlebar stem.
Art. n.: 464
Versione 10/18
Pagina 5/16