Start And Stop; Operating; When Taking A Break; Maintenance - Chicago Pneumatic CP FL 0022 VR Prescriptions De Sécurité Et Instructions Pour L'opérateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
CP FL 0022 VR, CP FL 0022 SVR

Start and stop

A
B
Models CP FL 0022 VR and CP FL 0022 SVR are
equipped with a throttle lever and a lock-off trigger.
The lock-off trigger is positioned inside the D-handle.
It locks the throttle lever (positioned on top of the
D-handle) and prevents the machine from starting
accidentally.
Start the machine by pulling the lock-off trigger
to position (C) and squeezing the throttle lever
towards position (B).
The vibration-damping handle must not be
pressed all the way down to the base.
Stop the machine by releasing the throttle lever
and the lock-off trigger. The throttle lever will
automatically return to position (A) and the
lock-off trigger will return to position (D).

Operating

Starting a cut
Stand in a stable position with your feet well away
from the inserted tool.
Press the machine against the working surface
before you start.
Start collaring in such a way that the machine is
capable of breaking the material without levering.
Never try to break off too large pieces. Adjust the
breaking so that the inserted tool does not get
stuck.
9800 0838 90c | Original instructions
Breaking
Let the machine do the work; do not press too
hard. The vibration-absorbing handle must
absolutely not be pressed all the way down to the
base.
C
For pneumatic machines with vibration-absorbing
D
handles: The feed force should be adapted so that
the handle is pressed down 'half way'. The best
vibration damping and breaking effect is achieved
at this position.
Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
Any form of idling, operating without insertion
tool or operating with an uplifted machine must
be avoided.
When the machine is lifted, the start and stop
device must not be activated.
Check regularly that the machine is well
lubricated.

When taking a break

During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Safety and operating instructions
Min
A
Max
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cp fl 0022 svr

Table des Matières