Cleaning - Brandy Best SILENTPRO20 Description Du Système Et Notice D'emploi

You will require a flathead screwdriver and a cross-headed screwdriver.
1) Remove the caps (1)
2) Unscrew the screws (2)
3) Remove the upper hinge (3)
4) Lift the door (4) and unscrew and remove the hinge (5)
5) Place hinge (5) on the opposite side and replace the screw
6) Replace the door on the desired side on hinge (5)
7) Replace the upper hinge (3) on the door and screw (2) it back into place
8) Replace the caps (1) and (6)

Cleaning

The mini-bar must be cleaned and maintained at least once a month.
During maintenance, ensure that the appliance is unplugged.
Cleaning the exterior of the mini-bar:
You can use soap to clean the exterior of the appliance. However you should ensure that the door is fully
closed in order to avoid contact between the product and the seal, or with the interior of the mini-bar. You can
also just use a damp cloth.
Cleaning the interior of the mini-bar:
You can clean the interior of your mini-bar with a mild solution of bicarbonate of soda. After, rinse with hot
water using a wrung cloth. Then wipe in order to remove any trace of moisture.
Pay attention to the maintenance of the rubber door seals. They must always be clean in order to avoid
mould.
NOTE: Do not use diluents, petrol, alcohol, kerosene, abrasive detergents, washing powder, acid, chemical
products, etc. in order to avoid damaging the plastic. It is discouraged to spray water directly onto the mi-
ni-bar. This could cause rusting.
Page 9