Clatronic HC 3361 Mode D'emploi page 26

Masquer les pouces Voir aussi pour HC 3361:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
All manuals and user guides at all-guides.com
WARNING:
• Cleaning and user maintenance must not be carried out by
children, unless they are supervised.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. To avoid the exposure to danger, always
have faulty cable be replaced only by the manufacturer, by our cus-
tomer service or by qualified person and with a cable of the same
type.
• If the device is used in the bathroom please remove the plug from
the socket after use as the proximity of water represents a hazard.
This also applies if the device is switched off.
• The hair straightener becomes hot during operation! Danger of
burning!
• Always remove the plug from the socket after use.
• Allow the device to cool down before cleaning it and storing it
away!
• As additional protection we recommend the installation of a fault
current protection device (RCD) with a rated current of not more
than 30 mA in the wiring system of the bathroom. Please contact an
authorised electrician for advice.
CAUTION:
This device is not intended to be immersed in water during cleaning.
• Please observe the instructions that we have included for you in the
chapter "Cleaning and Care".
Before Initial Use
Remove all the packing materials.
When the device is switched on for the first time there may
be a slight smell. You should therefore operate the device
for approximately 10 minutes without smoothing your hair.
Ensuring sufficient ventilation!
26
Commissioning
1. Fully unwind the mains cable.
2. Insert the plug in a duly installed socket.
3. Slide the switch on the handle to the "ON" position, to turn
on the device.
The control light will light up. After a few minutes, the device
is operational.

Publicité

Table des Matières
loading

Table des Matières