Table des Matières
Publicité
Ajusting the Flat Panel Tilt
19
TO ADJUST THE TILT TENSION OF THE AM175, LOOSEN THE TENSION BOLTS LOCATED ON THE BOTTOM RIGHT AND LEFT SIDE OF THE
MAIN ARM ASSEMBLY. RE-TIGHTEN THESE BOLTS TO ACHIEVE YOUR DESIRED TENSION.
POUR RÉGLER LA TENSION D'INCLINAISON AM175, DESSERRER LES BOULONS DE TENSION DANS LA PARTIE INFÉRIEURE DROITE ET DU
CÔTÉ GAUCHE DE L'ASSEMBLAGE DE L'AXE PRINCIPAL. RESERRER CES BOULONS POUR PARVENIR À LA TENSION DÉSIRÉE.
Adjusting the Flat Panel Down
Step 1. Place one hand at the center top edge of
the flat panel.
Step 2. Place the other hand on the center bottom
edge of the flat panel.
Step 3. Using the upper hand, gently pull the top
of the flat panel away from the wall while
the lower hand gently pushes the bottom of
the flat panel towards the wall.
Plastic Channel Cover Installation
20
Step 1. Place the plastic channel covers over the
Mounting plate (2 side covers and 1 center cover).
Step 2. Gently push each cover into place, covering the mounting
slots of the mounting place.
Repeats steps 1 and 2 for the installation for
of the lower plastic channel covers.
Répéter l'étape 1 et 2 pour l'installation des
couvercles en plastique du canal inférieur.
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d'Installation, Installatie gids
Tension
Bolt
Tension
Bolt
Adjusting the Flat Panel Down
Step 1. Place one hand at the center top edge of
the flat panel.
Step 2. Place the other hand on the center bottom
edge of the flat panel.
Step 3. Using the upper hand, gently push the top
of the flat panel towards the wall while
the lower hand gently pulls the bottom of
the flat panel towards the wall.
Center Cover
Side Cover
(Short)
(Long)
AM175
Installation Guide
Side Cover
(Long)
Page 11
Publicité
Table des Matières
