Table des Matières
Publicité
AM175
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d'Installation, Installatie gids
Attaching the Flat Panel to the Wall Plate
17
Two people are required for this step.
Il est requis deux personnes pour cette étape.
Step 1. Place the universal brackets and the flat panel over and onto the upper and lower mounting bars of the AM175 and lower it down. Do not release the flat panel
until the flat panel is resting securely on the upper and lower mounting bars.
Securing the Leveling the Flat Panel
18
In the event that the flat panel is tilted too far to
one side, the leveling screws will allow you to
compensate for this tilt by simply adjusting the
screws with a screwdriver (see illustration to the
right for a clearer view).
Au cas où l'écran plat penche fortement d'un côté,
les vis de réglage vous permettront de compenser
ce basculement en ajustant simplement les vis à
l'aide d'un tournevis (voir illustration à droite pour
une vue plus claire).
Step 1. Use a screwdriver to adjust the two (2) M6 x 30
leveling screws, located on the top of the mounting
brackets.
Step 2. Once the flat panel panel is level, ues a screwdriver
to tighten the two (2) M6 x 30 locking screws,
located on the bottom of the mounting brackets. Do
not over tighten these screws.
Page 10
Do
not
release
the
flat
panel
connection between the universal mounting brackets and the
upper and lower mounting bars.
Éviter de relâcher l'écran plat jusqu'à
connexion entre les supports de montage tous usages et les
poteaux de montage hauts et bas.
Upper Mounting Bar
Lower Mounting Bar
Flat Panel
until
verifying
the
ce que vous vérifiiez la
Screwdriver
Leveling Screw
(Pre-installed)
Locking Screw
(Pre-installed)
Publicité
Table des Matières
