Let's Go Aero BikeWing V4 Manuel Du Produit page 4

STEP 7:
Remove the pre-attached Tilt Pins from each Mast [H & J].
Slide the Stem [G] in-between the brackets on each Mast and align the holes vertically. [Fg. 9]
For Mast H [H]: Use the bottom vertically aligned hole. Secure the Stem using one (1) 8mm Bolt [N], two (2) 8mm Flat
Washers [O] and one (1) 8mm Nylock Nut [P] as shown. [Fg. 10]
For Mast J [J], use the top vertically aligned hole. Secure the Stem using one (1) 8mm Bolt [N], two (2) 8mm Flat Washers
[O] and one (1) 8mm Nylock Nut [P] as shown. [Fg. 10]
G
H
J
TILT PIN
TILT PIN
[Fg. 9]
STEP 8:
Install the Tilt Pins into each Stem to lock the tilt function.
[Fg. 11-12]
For Mast A [H], the Wire Lock Pin will go above the Tilt
Bolt. For Mast B [J] the Wire Lock Pin will go below the
Tilt Bolt.
G
[Fg.11]
G
[Fg. 10]
H
J
G
O
P
FOR OFF ROAD USE:
FOR OFF ROAD USE ALWAYS SECURE THE STEM [H]
WITH TWO 8mm BOLTS AS SHOWN [FG. 13]
P
TILT PIN
[Fg. 12]
Page 4 of 17
RECOMMENDED TOOL: 15MM WRENCH
N
O
G
P
O
WARNING:
G
O
O
N
O
N
[Fg. 13]