Let's Go Aero BikeWing V4 Manuel Du Produit page 3

STEP 4:
Unlatch the Tilt Pin attached to the Shank
[A].
Align the upper horizontal holes on
Shank [A] with the holes on the end of
Mast H [H].
Secure and re-latch the Tilt Pin into the
hole located closest to the vehicle.
In the 2nd hole, secure the Mast using
one (1) 10mm Bolt [K], two (2) 10mm Flat
Washers [L], and one (1) 10mm Nylock
Nut [M] as shown. [Fg. 5]
STEP 5:
[Fg. 6]
STEP 6:
Slide Mast J [J] onto Mast H [H].
Insert the Silent Hitch Pin [C] with Washers [E &D] into
the receiver hole and thread through the Spring Nut [N].
Tighten (30 ft.lbs. torque, or until 'snug') and secure
with Retainer Clip [F]. [Fg.8]
M
[Fg. 5]
H
B
Page 3 of 17
RECOMMENDED TOOL: 7/8" WRENCH
10MM TILT PIN
A
L
Slide Spring Nut [B] into the opening on Mast H [H] and align
the holes. [Fg. 6-7]
B
[Fg. 7]
RECOMMENDED TOOL: 7/8" WRENCH
F
[Fg. 8]
K
L
H
D
E
C
J