Corsair HYDRO Serie Mode D'emploi page 4

INSTALLATION
3. Power down your system.
4. Identify an available M.2 key M 2280 slot on
your system, referring to your motherboard or
system documentation.
6. Insert and secure M.2 with screw.
5. Remove any cover from the M.2 slot and
screws. Take care to ensure no screws
remain on standoffs for shorter M.2 cards.
3
7. Install the two (2) appropriate CORSAIR XF G1/4'' BSPP threaded-type fittings (not included) into
the water block ports and tighten them by hand. Do not use any tools to tighten (i.e. pliers)
8. Install tubing and secure it to finalize the adding of the water block to the water-cooling loop.
Do not forget to leak test the system before fully powering on your PC.
9. Flow orientation is not important. This product works great with flow in either direction.
4
ENGLISH