Connections; Connecting To The Aerial; Connections To Your Tv - LG DR4810 Mode D'emploi

Connections

ips
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the recorder. Use only one of the connections
described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
Caution
– Make sure the DVD Recorder is connected directly to
the TV. Tune the TV to the correct video input chan-
nel.
– Do not connect the DVD Recorder's AUDIO OUT jack
to the phono in jack (record deck) of your audio sys-
tem.
– Do not connect your DVD Recorder via your VCR.
The DVD image could be distorted by the copy pro-
tection system.

Connecting to the Aerial

Remove the aerial cable plug from your TV set and
insert it into the aerial socket at the back of the DVD
recorder. Plug one end of the aerial cable into the TV
socket on the DVD recorder and the other end into the
aerial input socket on your TV set.
RF coaxial connection
Connect the RF. OUT jack on the DVD Recorder to the
aerial input jack on the TV using the 75-ohm Coaxial
Cable supplied (R). The RF. OUT jack passes the signal
through from the AERIAL jack.
Aerial
ANTENNA
INPUT
R
All manuals and user guides at all-guides.com
Rear of TV
SCART INPUT
VIDEO
AUDIO INPUT
INPUT
R
L
Rear of DVD Recorder

Connections to Your TV

Make one of the following connections, depending on
the capabilities of your existing equipment.
When using the COMPONENT VIDEO OUT jacks,
set the VIDEO OUTPUT switch to COMPONENT.
When using the SCART jack, set the VIDEO OUT-
PUT switch to RGB.
SCART connection
Connect the EURO AV1 AUDIO/VIDEO scart jack on
the DVD Recorder to the corresponding in jacks on the
TV using the scart cable (T).
Video connection
Connect the VIDEO OUT jack on the DVD Recorder to
the video in jack on the TV using the video cable (V).
S-Video connection
Connect the S-VIDEO OUT jack on the DVD Recorder
to the S-Video in jack on the TV using the S-Video
cable (S).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks on the
DVD Recorder to the corresponding input jacks on the
TV using an Y Pb Pr cable (C).
Audio (Left/Right) Connection
Connect the left and right AUDIO OUT jacks of the DVD
Recorder to the audio left and right IN jacks on the TV
using the audio cables (A). Do not connect the DVD
Recorder's AUDIO OUT jack to the phono in jack
(record deck) of your audio system.
Rear of TV
SCART INPUT
S-VIDEO
COMPONENT VIDEO INPUT
INPUT
Y
T S
C
VIDEO
AUDIO INPUT
INPUT
Pb Pr R
L
A V
Rear of DVD Recorder
13